Config[Ure] Guidelines - HP T6553 D45 Reference Manual

FUP Commands
the interval is 30 seconds for disk transfers and 10 seconds for optical
transfers. The time you specify must be a positive number; 0 specifies the FUP
defaults.
Because each update to the RESTART file requires a synchronized update to
the TARGET file, smaller values can slow down a DUP[LICATE] process.
STATONLY
suppresses the implicit INFO DETAIL display if INFO STAT is specified.
XLATE xlate-table-name
specifies the name of a translation table that FUP can use in subsequent
COPY, LOAD, or BUILDKEYRECORDS commands when you use the XLATE,
XLATEIN, or XLATEOUT keyword in the command.
The xlate-table-name parameter is 24 characters long and can include
letters, numbers, underscores (_), hyphens (-), and circumflex (^) characters.
CHARMAP specifies a translation table from the CHARMAPS product (T9279).
If CHARMAP is specified, filename defaults to
$SYSTEM.SYSTEM.ZCHARMAP, and xlate-table-name must be one of
the defined tables in the CHARMAP file. CHARMAP is the default.
TEXT specifies a user-created translation table. If you specify TEXT, you must
also specify filename. FUP expects the translation table to be the first 512
bytes of an unstructured file from the first record of a structured file. If the
record is either longer or shorter than 512 bytes, FUP issues a warning
message.
Because FUP does not read filename until needed by a COPY, LOAD, or
BUILDKEYRECORDS command, the CONFIGURE command does not
provide error notification.
When used in a COPY, LOAD, or BUILDKEYRECORDS command, the
XLATEIN and XLATEOUT options specify direction:
XLATEIN
XLATEOUT
The XLATEOUT table is expected to be the reciprocal translation for the
XLATEIN table. The XLATE option is the same as XLATEIN.

CONFIG[URE] Guidelines


The ALLOW, DISPLAYBITS, and REPORTWIDTH commands from the previous
product versions of FUP are now CONFIGURE commands. However, for
compatibility, they are also supported as separate commands.

Any values specified in the CONFIGURE command are enabled until they are
reset (with a RESET CONFIGURE command) or until the FUP session ends. To
Specifies a translation using the first 256 bytes in the XLATE table
Specifies the second 256-byte section of the XLATE table
File Utility Program (FUP) Reference Manual—523323-014
[ TEXT|CHARMAP ] [ IN filename
2-31
CONFIG[URE] Guidelines
]