Port; Ptcpipfilterkey - HP NonStop SSH 544701-014 Reference Manual

•
Some of the privileged commands in SSHCOM are critical to the security of the system. Therefore granting
access to other user accounts than super.super must be carefully considered.
•
The parameters must be set contiguously, i.e. if one parameter FULLSSHCOMACCESSUSER<k> is not
defined the checking of FULLSSHCOMACCESSUSER<i> parameters stops.
•
This parameter set is valid whether a thawed OBJECTTYPE USER record exists in Safeguard or not. But if a
user is configured with C access in the OBJECTTYPE USER record as well as mentioned in the parameter set
PARTIALSSHCOMACCESSUSER<k>, then the user has full SSHCOM access.
•
If a user is included in parameter sets PARTIALSSHCOMACCESSGROUP<n> as well as sets
FULLSSHCOMACCESSUSER<i> or FULLSSHCOMACCESSGROUP<j>, then the user has full SSHCOM
access.
See also:
•
PARTIALSSHCOMACCESSGROUP<n>, FULLSSHCOMACCESSUSER<i>,
FULLSSHCOMACCESSGROUP<j>, LIFECYCLEPOLICYPUBLICUSERKEY
•
See table in "SSHCOM Access

PORT

Use this parameter to specify the port number a SSH2 server should listen on for incoming connections.
Parameter Syntax
PORT number
Arguments
number
Refers to the decimal number of a TCP/IP port.
Default
The default for this parameter is 22.
Considerations
•
The ICANN manages a list of "well-known" port numbers for various protocols (see
http://www.iana.org/assignments/port-numbers). 22 is the well-known port for the SSH protocol.
•
The choice for the port value in your specific environment will depend on the applications already running on
your NonStop systems, the ports in use, and your firewall configuration.

PTCPIPFILTERKEY

Use this parameter to specify a filter key to enable round-robin filtering with parallel library TCP/IP or TCP/IPV6.
Parameter Syntax
PTCPIPFILTERKEY password | *
Arguments
password
A password that serves as a key to enable round-robin filtering of multiple instances of SSH2 servers listening
on the same port. The password will override the value of the DEFINE =PTCPIP^FILTER^KEY, which may
have been passed to SSH2 at startup.
*
92 • Configuring and Running SSH2
Summary" in section "SSHCOM Command Reference".
HP NonStop SSH Reference Manual