HP NonStop SSH 544701-014 Reference Manual page 274

STN51 Workstation IP address not in range for requested service
The IP address of the remote workstation is not defined in the IPRANGE, or the IPRANGE is not defined.
STN52 This Telnet Host requires encryption at the Telnet workstation.
A workstation emulator running in PLAIN mode (without SSL encryption) attempted to connect to an encrypted STN
listener. The session is disconnected after a brief delay.
STN53 This telnet host does not support encryption at the workstation - session terminated.
A workstation emulator running with SSL encryption attempted to connect to a PLAIN (unencrypted) STN listener. This
message will usually not display on the emulator screen, but can be seen as plain text in network or sniffer traces.
STN54 session timed out waiting for user logon response
A session connected to a SERVICE with LOGON REQ, but the user did not respond to the logon prompt.
STN57 This 6530 emulator does not support required WSINFO
See STNCOM command WSINFO.
STN58 WSINFO address does not match network address
See STNCOM command WSINFO.
STN59 Input discarded
For an SSH session with no read active (TACL PAUSE-d etc), a very large amount of keyboard input was received.
Further input is discarded.
STN70 Reconnecting to resilient window #ZWNnnnn
Connection to a resilient service where an existing window from a previous session has been reconnected to the current
session
STN70 application $pname|pid xxxx xxxx|cpu,pin programfilename
When reconnecting to a resilient window, existing applications are listed for informational purposes.
STN71 Userid not allowed for this service
The selected SERVICE requires a specific userid.
STN72 Using userid from SSH
SYSTEM-USER is being used instead of STN15/STN16 prompt.
274 • STN Reference
HP NonStop SSH Reference Manual