HP NonStop SSH 544701-014 Reference Manual page 267

zstn-evt-trace-stop
"<STN process name> Trace stopped"
•
CAUSE: An STN trace was stopped.
•
EFFECT: None; informational only.
•
ACTION: The binary trace file may now be forwarded to support, or may be formatted using the GTRED
program.
zstn-evt-trace-segment
"<STN process name> Trace not started to <2> size <3> allocatesegment error <4>"
•
CAUSE: Error <4> encountered when allocating extended segment file <2> of size <3> bytes.
•
EFFECT: Tracing is not enabled.
•
ACTION: Correct any errors in the trace filename, or select a disk with more available space, then retry the
TRACE command.
zstn-evt-trace-object
"<STN process name> Trace not started to <2>; error reading object file"
This event is no longer used.
zstn-evt-takeover
"<STN process name> Backup process takeover due to: <2>"
•
CAUSE: STN backup process takeover. <2> specifies the reason, such as primary CPU failure, etc.
•
EFFECT: Backup process resumes STN operation. Any sessions active in the previous primary process are
lost. New sessions will be accepted immediately. Depending on backup CPU availability, a new backup
process is automatically started.
•
ACTION: If the reason for the backup takeover, such as primary CPU failure, is understood, then no action is
required. Otherwise, contact support.
zstn-evt-trace-error
"<STN process name> Trace not started to <2> size <3> error <4> / <5>"
•
CAUSE: An unusual error was encountered while opening a trace file.
•
EFFECT: Tracing is not enabled.
•
ACTION: Contact support. Retry the TRACE command.
zstn-evt-trace-size-file
"<STN process name> PARAM TRACE^SIZE must precede PARAM TRACE^FILE"
•
CAUSE: PARAM TRACE^SIZE followed PARAM TRACE^FILE
HP NonStop SSH Reference Manual
value is 15
value is 16
value is 17
value is 18
value is 19
value is 20
STN Reference • 267