Security [<Letter>]; Shutdown; Ssh_Default_Svc <Service-Name> | *None; Start Service <Service-Name - HP NonStop SSH 544701-014 Reference Manual

continuation character, so STNCOM T0801H01_24JAN2011_AAS, T0801G06_15DEC2010_AAT, or later, is required
to accept the commands in the SAVECFG output file.
SECURITY [<letter>]
SECURITY displays and modifies the application's security setting. This setting is initially established by the PARAM
SECURITY command, with a default of O.
If the parameter is omitted, the current setting is displayed. The value O is the default. The letter entered sets the
associated level of security. Users can choose from "NACGUO" selections, which are based on standard Guardian file
security interpretation. These letters assign access as follows:
•
N—Any local or remote user
•
A—Any local user
•
G—A group member or owner
•
C—A member of the owner's community (local or remote user with the same group ID as the owner)
•
O—The owner only
•
U—A member of the owner's user class (local or remote user with the same user ID as the owner)
The SECURITY letter controls access to sensitive commands by STNCOM users. Sensitive commands are defined as
commands that alter the STN configuration or operation. Sensitive commands can only be performed by STNCOM users
with a user ID matching the SECURITY setting. Non-sensitive commands, such as STATUS, INFO, and LISTOPENS,
can be performed by any user ID.

SHUTDOWN

SHUTDOWN initiates an STN process termination, which takes about three seconds. All active sessions are terminated.
There are no parameters.
You can also use the TACL STOP $STN command, but this can result in some warning messages.
SSH_DEFAULT_SVC <service-name> | *NONE*
SSH_DEFAULT_SVC defines a default service to be used when the SSH userid is configured with CI_PROGRAM
*MENU* (without anything following *MENU*). If SSH_DEFAULT_SVC is set to *NONE*, the default value, then
the STN02 service menu is displayed and the user must type in the service name or #SU window name. If
SSH_DEFAULT_SVC is set to any other value, then it is used as a service name and an STN73 message notifies the
user of this fact.
START SERVICE <service-name> | *
Activates a service previously STOPPED or ABORTED. New session requests for the service will be accepted. START
is automatically performed by ADD SERVICE, and is generally not used.
START WINDOW <#window-name> | *
Activates a service previously STOPPED or ABORTED. New session requests for the service will be accepted. START
is automatically performed by ADD SERVICE, and is generally not used.
STATUS SERVICE [ <service-name> | * ]
Displays current status information for the specified service or for all services.
246 • STN Reference
HP NonStop SSH Reference Manual