[B] Checks Before Installation; [C] Protective Film; [D] Operation Box - Hoshizaki JWE-2400CUA-L-25B Installation Manual

[b] CHECKS BEFORE INSTALLATION

1) Check the exterior including the front panel and service panel for damage.
 &KHFN WKH LQWHUQDO SDUWV LQFOXGLQJ WKH VSUD\ DUPV DQG ¿OWHUV IRU GDPDJH RU FORJJLQJ
3) The accessories except the rack are provided in the carton. Check that all the
DFFHVVRULHV OLVWHG LQ WKH LQVWUXFWLRQ PDQXDO VHH ³ >G@ $&&(6625,(6´ DUH LQFOXGHG
and not damaged.
1. Visually inspect the exterior of the shipping container and immediately report
any damage to the carrier. Upon opening the container, any concealed
damage should also be immediately reported to the carrier.
2. The instruction manual should be handed over to the user.

[c] PROTECTIVE FILM

%H VXUH WR UHPRYH WKH SURWHFWLYH SODVWLF ¿OP IURP WKH VHUYLFH SDQHO DQG RWKHU SDUWV ZKLFK
PD\ EHFRPH KRW GXULQJ RSHUDWLRQ 2WKHUZLVH WKH DGKHVLYH RQ WKH ILOP ZLOO PDNH WKH
stainless steel exterior look unclean.

[d] OPERATION BOX

Be sure to attach the operation box before installing the unit. It is prepared at the factory to
be attached to the exit side of the top panel.
1) Remove the bolts at the exit side of the top panel. Then, attach the operation box.
2) Insert the two operation box cables from the cable cover (L) on the rear side into the
notch in the rear panel, and route them into the machine compartment. Then, remove
the four bolts from the top panel, put the cables in the accessory cable cover (S), and
use the separator inside to keep the two cables away from each other. Secure the cable
cover (S) by using the four bolts removed.
The accessory cable cover (S) should be hooked into the square hole in the back of the
operation box as shown in the illustration.
3) Remove the front panel, and pull the cables from the back of the machine compartment.
Coil and tie any extra length of cable to prevent contact with the fan blades and other
sharp edges.
4) Remove the plastic bag from the operation box connection cables coming out of the
control box, and connect the 4P and 7P connectors. Cover the cable connections with
IMPORTANT
3