[D] After Trial Run - Hoshizaki JWE-2400CUA-L-25B Installation Manual

[d] AFTER TRIAL RUN

When cleaning the strainer at the end of installation, wait until the surface
temperature falls below 104°F (40°C) to avoid the risk of burns.
Do not install the unit where there is a risk of freezing. If there is a possibility
that the ambient temperature may fall below 32°F (0°C) and freeze the unit, be
sure to drain the unit. The water supply line could be damaged and leak water,
resulting in damage to the surrounding property.
 3UHVV WKH ³212))´ EXWWRQ
2) Pull out the drain pipe to drain wash water from the wash tank.
3) Turn off the water heater according to its instruction manual.
4) Clean the strainer to remove any debris from
the water supply connection. To remove the
strainer, turn the cap counterclockwise.
5) Use a dry soft cloth to wipe moisture off the
exterior and washing compartment.
[e] ADJUSTMENT
If any adjustment is required to the wash or rinse cycle time or temperature setting, contact
an authorized Hoshizaki service company.
[f] LOWER WASH SPRAY ARM PRESSURE AND FLOW RATE
7KH SUHVVXUH DQG ÀRZ UDWH RI WKH ORZHU ZDVK VSUD\ DUP DUH DGMXVWDEOH LQ WKUHH OHYHOV E\
the damper located on the lower wash pipe. To prevent plastic or other lightweight dishes
IURP VFDWWHULQJ DGMXVW WKH GDPSHU WR D SURSHU SUHVVXUH DQG ÀRZ UDWH
1) Unscrew the damper, then turn it to the desired number.
The lower wash spray arm jet force decreases as the number gets smaller. The damper
LV IDFWRU\ DGMXVWHG WR ³´
 8VH WKH VFUHZ WR ¿[ WKH GDPSHU LQ SRVLWLRQ
WARNING
CAUTION
17
Strainer
Cap
Mesh