[E] Hot Water Supply Connection; [F] Drain Connection (Wash Tank Drain) - Hoshizaki JWE-2400CUA-L-25B Installation Manual

[e] HOT WATER SUPPLY CONNECTION

To reduce the risk of burns, the hot water supply line must be thermally
LQVXODWHG +RW ZDWHU DURXQG ƒ) ƒ& ZLOO ÀRZ LQVLGH
* Where there is a risk of water hammer, it is recommended to install a water hammer
arrestor between the dishwasher and water heater.
* Required incoming water temperature:
Minimum
110 °F (43°C)
Wash Temperature
Minimum
160 °F (71°C)
2SWLRQDO FRQQHFWLRQ IRU ORZ WHPSHUDWXUH FRQGLWLRQV
Where there is a risk of freezing, install a drain valve (shut-off valve) between the water
supply valve and dishwasher.
When an instantaneous water heater is used, it must be an exclusive type for a
dishwasher and provided with an end stop system.

[f] DRAIN CONNECTION (WASH TANK DRAIN)

To ensure proper draining, do not route the drain pipe where it can be stepped
on.
'UDLQ OLQH VKRXOG EH SLWFKHG ´ SHU IRRW WR WKH ÀRRU
drain. An air gap of a minimum of 2 vertical inches (5 cm)
should be between the end of the drain pipe from the
GLVKZDVKHU DQG WKH ÀRRU GUDLQ
* If a grease trap is required in the drain line by regulations,
check that it is present at the time of installation.
Incoming Water Temperature
Recommended
140 °F (60°C)
Recommended
160 °F (71°C)
IMPORTANT
CAUTION
WARNING
Maximum
167 °F (75°C)
Rinse Temperature
Minimum
180 °F (82°C)
9
Recommended
180 °F (82°C)
Drain Pipe (pitched)
Floor Drain
Min 2"
(5cm)