Table Inserts - Grizzly G1071 Owner's Manual

Table Inserts

the model g1071 is supplied with three different
sized table inserts. the inserts are designed to
reduce the gap between the spindle and the table
opening. the hole in each insert is oblong to allow
clearance when the table is tilted.
NOTICE
always use the table insert with the small-
est opening that still allows at least
clearance around the spindle.
To install the table insert:
1. DISCONNECT SANDER fROM POWER!
2.
determine which table insert is best for the
particular spindle you are using.
3.
install the insert over the mounted spindle
and into the recessed hole on the table, as
shown in figure 25.
figure 25. Table insert.
model g1071 (mfg. 1/02+)
Note: The insert is fitted with pins that allow
it to fit into the table in only one position. This
ensures the table insert will not make con-
tact with the spindle even when the table is
tilted.
4. adjust the set screws shown in figure 26
so the top of the insert is flush with the table
surface.
⁄ "
1
8
figure 26. Adjusting table insert.
-21-