Grizzly G1071 Owner's Manual page 17

8.
move the square to various points around
the table to ensure the table and spindle are
square on all sides. adjust the stop bolt as
necessary until the table rests on the stop
bolt and is square with the spindle (figure
12).
figure 12. Table stop bolt (table tilted for clarity).
9.
tighten both table lock handles when you are
satisfied with the position of the table.
10. loosen the retainer screw (figure 13) that
secures the scale pointer and adjust the
scale pointer to read 0˚. re-tighten the retain-
er screw.
scale
retainer screw
figure 13. Pointer adjustment.
11. re-tighten the jam nut to secure the table
stop bolt (figure 12).
model g1071 (mfg. 1/02+)
scale pointer
12. insert one 3 x 20mm roll pin into the non-
threaded hole in each of the three table
inserts, as shown in figure 14. make sure
it does not extend through the surface of the
table insert.
table insert
figure 14. Inserting roll pins (bottom view).
13. thread four of the
1
the threaded holes on each table insert, as
shown in figure 15.
Note: The roll pins and set screws must not
protrude above the top surface of the table
insert or they will interfere with sanding oper-
ations.
set screw
(1 of 4)
Flat Top Surface
Set Screws
figure 15. Inserting set screws.
roll pin
⁄ "-20 x ⁄ " set screws into
5
4 8
table insert
Table Insert
Roll Pin
-15-