Transceiver Information; Modifying Port Operating Characteristics - Qlogic SANbox 5600 Series Interface Manual

6 – Port Configuration

Modifying Port Operating Characteristics

Transceiver Information

NOTE:
The Show Media command requires the SANdoctor license key. To
purchase a license key, contact your authorized maintenance provider or
authorized reseller.
Enter the
more transceivers as shown in the following example. Refer to
description of the transceiver information in the Show Media display.
SANbox #> show media 4
Port Number: 4
-------------
MediaType
MediaVendor
MediaPartNumber
MediaRevision
MediaSerialNumber
MediaSpeeds
Modifying Port Operating Characteristics
You can make permanent or temporary changes to port operating characteristics.
You make permanent port configuration changes using the
command. These changes are saved in the active configuration and are
preserved across switch or port resets. The
changes that apply until the next port or switch reset, or until you activate a
configuration.
NOTE:
8-Gbps SFPs do not support the 1-Gbps setting. Setting a port to 1-Gbps
that has an 8-Gbps SFP will down the port.
6-6
Show Media command to display operational information about one or
400-M5-SN-I
FINISAR CORP.
FTRJ8524P2BNL
A
P6G22RL
1Gb/s, 2Gb/s, 4Gb/s
Temp
(C)
----------- ----------- ------------ ----------- -----------
Value 37.32
Status Normal HighWarning
HighAlarm 95.00
HighWarning 90.00
LowWarning -20.00
LowAlarm -25.00
Voltage Tx Bias
(V) (mA)
3.33 7.30
Normal
3.90 17.00
3.70 14.00
2.90 2.00
2.70 1.00
Set Port
S
Table 14-39
Tx Pwr Rx Pwr
(mW) (mW)
0.373 0.000
Normal LowAlarm
0.637 1.264
0.637 0.791
0.082 0.028
0.073 0.019
Set Config Port
command makes temporary
59183-03 A
for a