Adding A Data Capture Configuration - Qlogic SANbox 5600 Series Interface Manual

A

Adding a Data Capture Configuration

Enter the
Tech_Support_Center profile as shown in the following example. If the
Tech_Support_Center profile does not exist, you must create it using the
Create command.
SANbox #> admin start
SANbox (admin) #> callhome edit
SANbox (admin-callhome) #> capture add
A list of attributes with formatting and default values will follow.
Enter a value or simply press the ENTER key to accept the default value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Value (press ENTER to accept the default, 'q' to quit):
TimeOfDay
DayOfWeek
Interval
A capture entry has been added to profile Tech_Support_Center.
This configuration must be saved with the 'callhome save' command
before it can take effect, or to discard this configuration
use the 'callhome cancel' command.
59183-03 A
Capture Add command to add a data capture configuration to the
(HH:MM)
(Sun,Mon,Tue,Wed,Thu,Fri,Sat)
(decimal value, 1-26 weeks)
12 – Call Home Configuration
Managing the Call Home Database
[02:00]
[Sat ]
[1 ]
Profile
12-13