Dns Server Configuration - Qlogic SANbox 5600 Series Interface Manual

A

DNS Server Configuration

A DNS server manages the host names for a fabric. This enables you to specify
servers and switches by a meaningful name rather than IP address. To configure
a DNS server, enter the
shown in the following example:
SANbox (admin) #> set setup system dns
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
DNSClientEnabled
DNSLocalHostname
DNSServerDiscovery
DNSServer1Address
DNSServer2Address
DNSServer3Address
DNSSearchListDiscovery
DNSSearchList1
DNSSearchList2
DNSSearchList3
DNSSearchList4
DNSSearchList5
New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):
DNSClientEnabled
DNSLocalHostname
DNSServerDiscovery
DNSServer1Address
DNSServer2Address
DNSServer3Address
DNSSearchListDiscovery
DNSSearchList1
DNSSearchList2
DNSSearchList3
DNSSearchList4
DNSSearchList5
Do you want to save and activate this system setup? (y/n): [n]
59183-03 A
Set Setup System Dns command in an Admin session as
False
<undefined>
Static
<undefined>
<undefined>
<undefined>
Static
<undefined>
<undefined>
<undefined>
<undefined>
<undefined>
(True / False)
(hostname)
(1=Static, 2=Dhcp, 3=Dhcpv6) :
(IPv4, or IPv6 Address)
(IPv4, or IPv6 Address)
(IPv4, or IPv6 Address)
(1=Static, 2=Dhcp, 3=Dhcpv6) :
(domain name)
(domain name)
(domain name)
(domain name)
(domain name)
4 – Network Configuration
Configuring the Ethernet Port
:
:
:
:
:
:
:
:
:
:
4-5