Add Members To A Group - Qlogic SANbox 5600 Series Interface Manual

A

Add Members to a Group

Adding a member to a group involves specifying a group, the member worldwide
name, and the member attributes. The member attributes define the
authentication method, encryption method, secrets, and fabric binding, depending
on the group type.
For ISL member attributes, refer to
For Port member attributes, refer to
For MS member attributes, refer to
Enter the
SANbox #> admin start
SANbox (admin) #> security edit
SANbox (admin-security) #> group add Group_1
A list of attributes with formatting and default values will follow
Enter a new value or simply press the ENTER key to accept the current value
with exception of the Group Member WWN field which is mandatory.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Group Name Group_1
Group Type ISL
Member (WWN)
Authentication (None / Chap)
PrimaryHash (MD5 / SHA-1)
PrimarySecret (32 hex or 16 ASCII char value)
SecondaryHash (MD5 / SHA-1 / None)
SecondarySecret (40 hex or 20 ASCII char value)
Binding (domain ID 1-239, 0=None)
Finished configuring attributes.
To discard this configuration use the security cancel command.
59183-03 A
Group Add command to add a member to a group:
9 – Device Security Configuration
Table 14-2.
Table 14-3.
Table 14-4.
[00:00:00:00:00:00:00:00] 10:00:00:c0:dd:00:90:a3
[None
[MD5
[
[None
[
[0
Managing Groups
] chap
]
] 0123456789abcdef
]
]
]
9-13