Restoring The Configuration File - Qlogic SANbox 5600 Series Interface Manual

5 – Switch Configuration
Managing Switch Configurations

Restoring the Configuration File

The restore operation begins with FTP to upload the configuration file from the
workstation to the switch, then finishes with a Telnet session and the Config
Restore command. To upload the configuration file, config_switch_169_10112003
in this case, open and FTP session with account name images and password
images. Transfer the file in binary mode with the Put command as shown in the
following example:
ftp ip_address
user: images
password: images
ftp> bin
ftp> put config_switch_169_10112003 configdata
Local file config_switch_169_10112003
Remote file configdata
ftp>quit
The restore process replaces all configuration information on the switch and
afterwards the switch is automatically reset. If the restore process changes the IP
address, all management sessions are terminated. Use the
command to return the IP configuration to the values you want. To restore the
switch, open a Telnet session (a new IP address may be required), then enter the
Config
example:
SANbox #> admin start
SANbox (admin) #> config restore
The switch will be reset after restoring the configuration.
Please confirm (y/n): [n] y
Alarm Msg: [day month date time year][A1005.0021][SM][Configuration is being
restored -
Alarm Msg: [day month date time year][A1000.000A][SM][The switch will be reset in
3 seconds due to a config restore]
SANbox (admin) #>
Alarm Msg: [day month date time year][A1000.0005][SM][The switch is being reset]
5-16
Restore command from within an Admin session as shown in the following
this could take several minutes]
S
Set Setup System
59183-03 A