Precor EFX556i Owner's Manual page 28

C O M M E R C
QUICKSTART: This key lets you bypass the Setup prompts and start your work-
out immediately using the Manual program. Default values apply.
QUICKSTART Default Values
Prompts
Program
Time
Weight
Age
Note: The POLAR
Optional Equipment on page 9.
The QUICKSTART key can be pressed any time during the Setup prompts. De-
fault values apply after that point. See the table below:
Press QUICKSTART at the...
Precor banner
PROGRAM prompt
TIME prompt
WEIGHT prompt
AGE prompt
page 28
I A L P R O D
Default Value
Manual
The Club limit (refer to page 20). Note that the Weight Loss
program is fixed at 28 minutes.
150 lbs. (68 kg.)
0 : A valid Age must be entered to utilize the SmartRate
display. If QUICKSTART is pressed after an age is entered,
then the SmartRate
the touch-sensitive grips on the handrail or wear the POLAR
chest strap. If no "Age" entry occurs, the SmartRate
lights up, but no blinking sensor appears.
® chest strap is available through your Precor dealer. Refer to
The following occurs:
You bypass the Setup prompts and your work out
begins in the Manual program.
The displayed program is accessed.
Note: Since a default workout time is accessed,
no progress message (such as 10% complete)
will appear on the display. The exception to this
rule is the Weight Loss Program.
The time that appears on the display becomes
the workout time limit. Time may be set to any
value from 1 to the Club limit. If "unlimited" work-
out time is allowed by the Club, you can select it
by entering 0 with the numeric key.
The weight that appears on the display becomes
your designated weight that the EFX uses to
compute statistics. Acceptable entries are
between 1 and 999.
The age that appears on the display becomes
the your designated age that the EFX uses to
compute statistics. A correct age entry between
1 and 99 is very important if you plan to utilize
the heart rate characteristics of the EFX. The
QUICKSTART key acts the same as the EN-
TER key at this point because you have answered
all the Setup prompts.
U C T S D I
® display will appear when you hold onto
V I S I O N
®
®
®
display