Precor EFX556i Owner's Manual page 14

C O M M E R C
Diagram 8 Secure the rear handlebar linkage.
Wrench tighten the screw. Once it
is secured, use a torque wrench
set at 200 in-lbs.
Handlebar linkage
c. Wrench tighten using a
Important: Once the fasteners are secured, use a hex torque wrench to
tighten the two linkage arm screws to 200 in-lbs.
Diagram 9 Align and secure
the front portion of
the handlebar
linkage. Cap the
rear portion.
Gap around
edge of linkage
should remain
consistent
Black plastic cap
7. Align the handlebar linkage with the handlebar. Diagram 9, #1. Return to
the handlebar bracket and straighten the handlebar so that the linkage below it
is set close to a 90 degree angle. Tighten the three screws on each handlebar
using a -inch hex key.
8. Install the plastic cap onto the linkage arms. Diagram 9, #2. Position the
plastic cap over the fasteners and press on it so it snaps it into place.
page 14
I A L P R O D
-inch socket wrench. Diagram 8.
1
U C T S D I V
2
I S I O N