Running Cable Diagnostics - Extreme Networks ExtremeWare Version 7.8 Troubleshooting Manual

Running Cable Diagnostics

You can run the CDM tests manually at any time, or you can schedule them to be run automatically.
Running CDM tests Manually. To run the tests manually, use this command:
run diagnostics cable port [<portlist> | all]
This command initiates the CDM to obtain cable diagnostics values for the specified physical ports of
the system.
NOTE
Running the cable diagnostics takes the link down, disrupting any network traffic on the specified port
and its link.
To stop a CDM run that is currently in progress, use this command:
abort diagnostics cable
Running CDM Tests Automatically. To run the CDM tests automatically, perform these steps:
1 First, create a template for auto diagnostics that specifies two parameters:
• Start time for the cable diagnostics
• Whether a port is to be restarted if the diagnostics run results in a failure for a particular port
To create the auto diagnostics template, use this command:
configure diagnostics cable time <time> {reset-port-on-failure [enable | disable]}
where
time
NOTE
If you specify
port, which is disabled prior to running the diagnostics, will remain disabled and the status LED
corresponding to the failed port will blink continuously. If you do not explicitly enable such ports, the
status LED corresponding to the failed port will continue to blink.
2 Next, enable auto diagnostics for specific ports by using this command:
enable diagnostics cable port [<portlist> | all]
NOTE
Running the cable diagnostics automatically takes the link down, disrupting any network traffic on the
specified port and its link.
To disable the automatic running of cable diagnostics for selected physical ports of the system, use this
command:
disable diagnostics cable port [<portlist> | all]
Advanced System Diagnostics and Troubleshooting Guide
is the time at which the diagnostics must be started, specified in the form hh:mm:ss.
reset-port-on-failure
and set it to , and the diagnostics fail for a port, the
disable
Cable Diagnostics
97