Extreme Networks ExtremeWare Version 7.8 Troubleshooting Manual page 65

Automatic Packet Memory Scan (via sys-health-check)
During the memory scan, the CPU utilization is high and mostly dedicated to executing the
diagnostics—as is normal for running any diagnostic on the modules. During this time, other network
activities where this system is expected to be a timely participant could be adversely affected, for
example, in networks making use of STP and OSPF.
The alarm-level option of the global system health check facility does not attempt to diagnose a
suspected module; instead, it simply logs a message at a specified level.
The auto-recovery option does attempt to diagnose and recover a failed module a configured number of
times. You should plan carefully before you use this command option. If you enable the system health
check facility on the switch and configure the auto-recovery option to use the offline auto-recovery
action, once a module failure is suspected, the system removes the module from service and performs
extended diagnostics. If the number of auto-recovery attempts exceeds the configured threshold, the
system removes the module from service. The module is permanently marked "down," is left in a
non-operational state, and cannot be used in a system running ExtremeWare 6.2.2 or later. A log
message indicating this will be posted to the system log.
NOTE
Keep in mind that the behavior described above is configurable by the user, and that you can enable
the system health check facility on the switch and configure the auto-recovery option to use the online
auto-recovery action, which will keep a suspect module online regardless of the number of errors
detected.
Example log messages for modules taken offline:
01/31/2005 01:16.40 <CRIT:SYST> Sys-health-check [ACTION] (PBUS checksum)
(CARD_HWFAIL_PBUS_CHKSUM_EDP_ERROR) slot 3
01/31/2005 01:16.40 <INFO:SYST> Card in slot 1 is off line
01/31/2005 01:16.40 <INFO:SYST> card.c 2035: Set card 1 to Non-operational
01/31/2005 01:16.40 <INFO:SYST> Card in slot 2 is off line
01/31/2005 01:16.44 <INFO:SYST> card.c 2035: Set card 2 to Non-operational
01/31/2005 01:16.44 <INFO:SYST> Card in slot 3 is off line
01/31/2005 01:16.46 <INFO:SYST> card.c 2035: Set card 3 to Non-operational
01/31/2005 01:16.46 <INFO:SYST> Card in slot 4 is off line
01/31/2005 01:16.46 <INFO:SYST> card.c 2035: Set card 4 to Non-operational
Advanced System Diagnostics and Troubleshooting Guide 65