Table of Contents
Advertisement
Packet Errors and Packet Error Detection
The slow-path and fast-path categories each have a separate configured threshold and associated action
that occurs at the end of the 20-second window:
• For the slow-path category, the three types of slow-path subcategory reports are tallied and
compared to the configured slow-path subcategory threshold.
• For the fast-path category, the two types of fast-path subcategory reports are tallied and compared to
the configured fast-path subcategory threshold.
If either of these thresholds is exceeded, that window is marked as a "bad" window. For each bad
window, the interpreting and reporting subsystem inserts a Sys-health-check error message into the
system log, indicating the primary reason why the window was marked bad.
The interpreting and reporting subsystem also maintains a running history of the windows it processes.
After it completes the window processing cycle, the interpreting and reporting subsystem examines the
window history list and counts the number of bad windows in the list. The bad window count is
compared to a configured window error parameter value. If the bad window count equals or exceeds
the window error parameter value, the interpreting and reporting subsystem alerts the system health
check system that there is a potential service-affecting condition. The system health check system will
then take the action specified in the
see
"Health Check Functionality" on page
• Insert an error message into the system log
• Send an SNMP trap to the configured trap receivers
• Take an offending module offline
• Take the entire switch offline
• Attempt to perform an automated recovery through the use of the packet memory scanning and
mapping capability
NOTE
The default system health check action is to insert an error message into the system log, but in many
environments, it is advisable to configure the system health check to send a trap to configured trap
receivers to provide faster notification of potentially service affecting conditions.
The interpreting and reporting subsystem is enabled by default, and the default values for the slow-
and fast-path thresholds and bad window counters depend on the switch platform type (see
Table 4: Default Threshold and Counter Values
Minimum Summit " i "
Slow-path threshold
1
Fast-path threshold
1
Window history
1
Window errors
1
32
configure sys-health-check
71):
Alpine
3802
3804
2
2
2
1
1
2
3
3
3
3
3
3
command (for more information,
BlackDiamond
3808
6808/6804
6816
2
2
2
3
6
12
3
3
3
3
3
3
Advanced System Diagnostics and Troubleshooting Guide
Table
4).
Maximum
254
254
32
32
Advertisement
Table of Contents
Troubleshooting
