Extreme Networks Summit WM Getting Started Manual page 86

Wireless AP configuration
Table 10: Composite view of three LED lights (Continued)
Left LED
Blinking
Green
Solid Green
NOTE
The Left and Right LEDs turn on after the center LED. This allows you to distinguish easily between the center LED
and the Left/Right LEDs.
NOTE
If the Center LED begins blinking RED, it indicates that the Wireless AP's state has failed.
NOTE
Random delays do not occur during normal reboot. A random delay only occurs after vulnerable period power-down.
The Wireless AP can be reset to its factory default settings. For more information, see
its factory default settings" on page
86
Right LED Centre LED
Off Blinking
Green /
Orange
Blinking Red
Blinking Green Blinking
Green /
Orange
Blinking Red
Solid Green Blinking
Green /
Orange
Blinking Red
Off Blinking
Green /
Orange
Blinking Red
Blinking Green Blinking
Green /
Orange
Blinking Red
Solid Green Blinking
Green /
Orange
Blinking Red
Blinking Green Solid Green /
Orange
Blinking Red
81.
Altitude AP's Detailed state
Network discovery: 802.1x authentication
Failed 802.1x authentication
Network discovery: DHCP
Default IP address
Network discovery: WM discovery / connect
Discovery failed
Connecting with Summit WM Controller: Registration
Registration failed
Connecting with Summit WM Controller: Image upgrade
Image upgrade failed
Connecting with Summit WM Controller: Configuration
Configuration failed
AP operating normally: Forced image upgrade
Image upgrade failed
Summit WM Getting Started Guide, Software Version 5.1
"Resetting the Wireless AP to