Extreme Networks Summit WM Getting Started Manual page 21

Table 1: LED states and SSD codes during firmware initialization (Continued)
Active LED Warning LED
Green
Green
Green
Green
NOTE
Although the Active LED will be lit Green during the firmware initialization, this LED state is irrelevant to the SSD
display or the condition. You must ignore the LED state during the firmware initialization.
Application initialization:
Table 2: LED states and SSD codes during application initialization
Active LED Warning LED
Green
Green
Green
Green
Warning conditions:
Table 3: LED states and SSD codes during warning conditions
Active LED Warning LED
Green Yellow
Green Yellow
Green Yellow
Green Yellow
Green Yellow
Summit WM Getting Started Guide, Software Version 5.1
Error LED SSD Codes
5
6
9
b
Error LED SSD Code
0
1
A
H
Error LED SSD Code
1
2
3
4
5
Condition
The system is formatting memory.
The system is initializing load device.
Note: If the SSD code is stuck at 6 for more than
a minute, it implies that the Network Processor
Card is installed in wrong slot.
The system is loading subsystem.
The system is starting the operation system. The
system is active.
Condition
Application initialization started.
Forwarding Engine initialization complete.
Application initialization.
Application initialization complete. System active.
System halted. Administrator requested halting of
system.
Condition
High temperature reached.
Fan unit failure. Rotation counter indicates zero
speed for one of the lateral trays. May be the result
of fan tray removal.
Power supply failure. Failed to detect one of the
power supplies. May be the result of the fan tray
removal of one of the power supplies.
FDD low sector count (40 backup sectors
remaining).
FDD extremely low sector count (20 backup sectors
remaining)
21