Extreme Networks Summit WM Getting Started Manual page 116

Availability and Mobility configuration
5 In the Security Mode section, click Allow only approved Altitude APs to connect.
6 From the main menu of the secondary Summit WM Controller, click Altitude APs. The Altitude AP
screen is displayed.
7 Repeat Step 3 to Step 5.
8 From the main menu of the primary Summit WM Controller, click Altitude APs. The Altitude AP
screen is displayed.
9 In the left menu, click Access Approval. The Access Approval screen is displayed.
10 Check the status of every Wireless AP and approve all those that should be connected to the primary
Summit WM Controller.
NOTE
You must delete all such Wireless APs that are in pending state and you do not intend to approve them.
11 From the main menu of the secondary Summit WM Controller, click Altitude APs. The Altitude AP
screen is displayed.
12 Repeat Step 9 to Step 10.
13 To save your changes, click Save.
NOTE
After you have assigned Wireless APs to their home Summit WM Controllers, you must check Active Wireless APs
Report screen to ensure that all those approved APs are indeed connected to their home Summit WM Controller.
For more information, see
Enabling availability pair, defining primary Summit WM
Controller, and selecting security mode
Steps 4, 5 and 6 of the availability configuration process involve enabling availability pair, defining
primary Summit WM Controller, and selecting security mode.
To enable the availability pair, define the primary Summit WM Controller, and select the security
mode:
1 Login on both the Summit WM Controllers.
2 From the main menu of the primary Summit WM Controller, click Altitude AP. The Altitude AP
screen is displayed.
3 In the left pane, click WAP Registration. The Altitude WAP Registration screen is displayed.
4 In the Registration mode section, click Paired.
5 From the main menu of the secondary Summit WM Controller, click Altitude APs. The Altitude AP
screen is displayed.
6 In the Registration mode section, click Paired.
7 From the main menu of the primary Summit WM Controller, click Altitude APs.
8 In the Summit WM Controller IP Address text box, type the IP address of the physical port of the
secondary Summit WM Controller.
9 Select Current Summit WM Controller is primary connection point.
116
"Viewing the active Wireless APs report" on page 118.
Summit WM Getting Started Guide, Software Version 5.1