Extreme Networks Summit WM Getting Started Manual page 34

Summit WM Controller, Access Points, and Software Solution
Table 6: Information gathering table (Continued)
Configuration data
Mobility manager
information
Mobility agent
information
34
Description
• Port – The interface of the Summit WM Controller that is
to be used as the mobility manager. Ensure that the
selected interface is routable on the network.
• Heartbeat – The time interval (in seconds) at which the
mobility manager sends a heartbeat message to the
agent. The default is 5.
• Port – The interface of the Summit WM Controller that is
to be used as the mobility agent.
Ensure that the selected interface is routable on the
network.
• Heartbeat – The time interval (in seconds) for which the
mobility agent should wait for the connection
establishment response before trying again. The default
is 60.
• Discovery Method – The method by which the mobility
agent will discover the mobility manager. You have the
following two options:
> SLPD (Service Location Protocol Daemon) – Enables the
discovery of mobility manager Summit WM Controller,
using SLP. The mobility manager's address must be
configured on the network using SLP when selecting this
option.
> Static Configuration – Allows the mobility agent to
discover the mobility manager without the SLP support.
If you select Static Configuration, you will need the IP
address of the Summit WM Controller that will serve as
the mobility manager.
Your entry
Summit WM Getting Started Guide, Software Version 5.1