Extreme Networks ExtremeWare 7.2e Installation And User Manual page 323

To access the BootROM menu, follow these steps:
1 Attach a serial cable to the console port of the switch.
2 Attach the other end of the serial cable to a properly configured terminal or terminal emulator,
power cycle the switch while depressing the spacebar on the keyboard of the terminal.
As soon as you see the
pressing
h
— Selecting the image to boot from
— Booting to factory default configuration
— Performing a serial download of an image
For example, to change the image that the switch boots from in flash memory, press
stored in primary or
selected on-board flash memory.
To boot to factory default configuration, press the
configured on-board flash.
To perform a serial download, you can optionally change the baud rate to 115200 using the
Then press the
1K XMODEM protocol. (You can use a Windows Hyperterminal program to accomplish this step.) After
the transfer is complete, the switch restores the console port to 9600 bps and begins the boot process.
ExtremeWare 7.2e Installation and User Guide
BootROM->
. Options in the menu include
for the image stored in secondary. Then, press the
2
key to prepare the switch for an image to be sent from your terminal using the
s
prompt, release the spacebar. You can see a simple help menu by
key for default and the
d
Upgrading and Accessing BootROM
for the image
1
key to boot from newly
f
key to boot from the
f
command.
b
323