Extreme Networks ExtremeWare 7.2e Installation And User Manual page 73

Table 18: Common Commands (Continued)
Command
configure account <user account> {encrypted}
{<password>}
configure banner
configure banner netlogin
configure ports [<portlist> | all | mgmt] auto off
{speed [10 | 100 | 1000]} duplex [half | full]
configure ssh2 key {pregenerated}
configure sys-recovery-level [none | [all | critical] [
reboot | shutdown | | reboot | shutdown]]]
configure time <date> <time>
configure timezone {name <std_timezone_ID>}
<GMT_offset> {autodst {name <dst_timezone_ID>}
{<dst_offset>} {begins [every <floatingday> | on
<absoluteday>] {at <time_of_day>} {ends [every
<floatingday> | on <absoluteday>] {at
<time_of_day>}}} | noautodst}
configure vlan <vlan name> ipaddress <ipaddress>
{<netmask> | <mask length>}
create account [admin | user] <username>
{encrypted} {<password>}
create vlan <vlan name>
delete account <username>
delete vlan <vlan name>
disable bootp vlan [<vlan name> | all]
disable cli-config-logging
disable clipaging
disable idletimeouts
disable ports [<portlist> | all]
disable ssh2
ExtremeWare 7.2e Installation and User Guide
Description
Configures a user account password.
The switch will interactively prompt for a new password, and
for reentry of the password to verify it. Passwords must have
a minimum of 1 character and can have a maximum of 30
characters. Passwords are case-sensitive; user names are
not case sensitive.
Configures the banner string. You can enter up to 24 rows
of 79-column text that is displayed before the login prompt of
each session. Press [Return] at the beginning of a line to
terminate the command and apply the banner. To clear the
banner, press [Return] at the beginning of the first line.
Configures the network login banner string. You can enter
up to 1024 characters to be displayed before the login
prompt of each session.
Manually configures the port speed and duplex setting of
one or more ports on a switch.
Generates the SSH2 host key.
Configures a recovery option for instances where an
exception occurs in ExtremeWare.
Configures the system date and time. The format is as
follows:
mm/dd/yyyy hh:mm:ss
The time uses a 24-hour clock format. You cannot set the
year past 2036.
Configures the time zone information to the configured offset
from GMT time. The format of gmt_offset is +/- minutes
from GMT time. The autodst and noautodst options
enable and disable automatic Daylight Saving Time change
based on the North American standard.
Additional options are described in the
Command Reference Guide
.
Configures an IP address and subnet mask for a VLAN.
Creates a user account. This command is available to
admin-level users and to users with RADIUS command
authorization. The username is between 1 and 30
characters, the password is between 0 and 30 characters.
Creates a VLAN.
Deletes a user account.
Deletes a VLAN.
Disables BOOTP for one or more VLANs.
Disables logging of CLI commands to the Syslog.
Disables pausing of the screen display when a show
command output reaches the end of the page.
Disables the timer that disconnects all sessions. Once
disabled, console sessions remain open until the switch is
rebooted or you logoff. Telnet sessions remain open until
you close the Telnet client.
Disables a port on the switch.
Disables SSH2 Telnet access to the switch.
Common Commands
ExtremeWare 7.2e
73