Extreme Networks ExtremeWare 7.2e Installation And User Manual page 274

Using ExtremeWare Vista on the Summit 400
Figure 66: IP Interface Configuration for RIP
Using this portion of the window, you can:
• Review the existing RIP configuration for an IP interface.
Each VLAN shows:
— The VLAN name
— The IP address
— Whether IP forwarding is enabled or disabled
— Whether RIP is enabled or disabled
— The RIP version used in receive mode (Rx)
— The RIP version used in transmission mode (Tx)
• Enable or disable RIP on a VLAN
• Configure RIP on a VLAN
• Set the Tx mode values for the selected VLANs. The pull-down menu allows you to specify the
following:
None—Do not transmit any packets on this interface.
V1 Only—Transmit RIP v1 format packets to the broadcast address.
V1 Compatible—Transmit RIP v2 format packets to the broadcast address.
V2 Only—Transmit RIP v2 format packets to the RIP multicast address.
If no VLAN is specified, the setting is applied to all VLANs. The default setting is V2 Only.
274 ExtremeWare 7.2e Installation and User Guide