Driver Installation - Elo TouchSystems ET3201L User Manual

Audio
Audio from the touchmonitor Line In, touchmonitor HDMI, touchmonitor DisplayPort, Computer
Module Line In, or Computer Module HDMI or DisplayPort ports can be played over the
touchmonitors internal speakers. See the "Audio Source" OSD parameter for details. When
headphones are plugged into the headphone output jack, the internal speakers turn off and
audio is played over the headphones.
Volume and muting of the speaker and headphone outputs can be controlled by the OSD.
MDC Functionality
The touchmonitor has the ability to allow remote access from a host computer. By installing the
IDS Utilities Suite, the user can access to the MDC tool. Using the MDC tool, the use can send
a variety of commands from a host PC to the touchmonitor. For detailed information, refer to the
utilities suite user guide.
RFID Functionality
For 3201L/4201L Units:
There is an integrated RFID antenna within the monitor. To enable the RFID functionality, a
RFID reader module (available at www.elotouch.com) must be installed and connected to the
integrated monitor antenna.
Refer to the RFID peripheral installation guide for proper hardware and software installation
techniques.
For the 7001L unit, an external peripheral kit is available from Elo.

Driver Installation

For units that will be using the Elo Computer Module (ECMG2-i3 or i5), all the drivers will come
preinstalled.
An external CD-Rom drive is required in order to install the drivers onto the host computer.
For No Operating System (OS) units, the drivers are provided on the accompanying driver CD
and they will also be available online at www.elotouch.com.
For Windows Operating Systems
After the computer has booted up, follow these instructions to install the drivers:
- Attach the external CD-Rom drive to the monitor and turn the computer on
- Insert the drivers CD
User Manual– Interactive Digital Signage
SW601990 Rev A, Page 23 of 32