Table of Contents
Advertisement
Menu/ Picture
Shown only when Signal Source is attached
1.
Press MENU button of remote control or projector to turn on the OSD.
2.
Press
button to Picture category.
3.
Press
button to select the beneath function for your needs.
4.
Press the
button key to adjust the modes or function values
5.
Press Enter key to confirm the selection
6.
Press MENU to leave the menu or press ▲ button to back to menu category after Enter key confirming the
selection.
Feature
Picture mode
Brightness
Contrast
Color
Tint
Sharpness
NOTE: The apparent brightness of the projected image will vary depending on the ambient lighting
conditions. Input contrast/brightness signal settings in accordance with projection distance.
Selection
Dynamic mode
Appropriate for playing colorful movies, video clips.
Presentation mode
Maximize the brightness of the projected image.
Set the different image values, brightness, contrast, color,
User mode
tint, and sharpness.
0~100
Picture mode is "User Mode" only.
(Dark ~ Bright)
Adjust the brightness of the image.
Picture mode is "User Mode" only.
-50 ~ 50
Adjust the contrast of the image.
Picture mode is "User Mode" only.
0 ~ 200
Adjust the intensity of the color in the image.
VGA have no this function support.
Picture mode is "user Mode" only.
0 ~10
Adjust the balance of red to green necessary for realistic
(Reddish ~
representation of Video signals.
Greenish)
VGA have no this function support.
Picture mode is "User Mode" only.
0~31
Adjust the image to make it look sharper.
(At higher values, will switch to detail enhancement)
Description
19
Advertisement
Table of Contents
