Table of Contents
Advertisement
Trouble Shooting
No power
There is no power from the power
cord.
Attempting to turn the projector on
again during the cooling process.
No image/ Image
adjustment
The video source is not turned on or
connected correctly.
The projector is not correctly
connected to the input signal device.
The input signal has not been
correctly selected.
The lens cover is still closed.
The projection lens is not correctly
focused.
The projector and the screen are not
aligned properly.
No audio
Remote control
The battery is out of power.
There is an obstacle between the
remote control and the projector.
You are too far away from the
projector.
Remedy
Plug the power cord into the AC inlet on the projector, and plug the power
cord into the power outlet.
Wait until the cooling down process has completed.
Remedy
Turn the video source on and check that the signal cable is connected
correctly.
Check the connection.
Select the correct input signal using MENU button on the projector or the
SOURCE button on the remote control.
Open the lens cover.
Adjust the focus of the lens using the focus ring.
Adjust the projection angle and direction as well as the height of the
projector if necessary.
The projector is not connected correctly.
Check audio cable if connect correctly.
The volume is set to minimum.
Adjust the volume.
Mute is turned on.
Press the MUTE button.
Remedy
Replace the battery with a new one.
Remove the obstacle.
Stand within 5 meters of the projector.
31
Advertisement
Table of Contents
