Setting Up; Power On The Projector - Eiki EIP-XSP2500 Owner's Manual

Dlp projector

Hide thumbs Also See for EIP-XSP2500:

Table of Contents

Setting Up

1. Complete peripheral connections (with a

Computer, VCR/DVD, etc.) before turning on the

projector

2. Plug the power cord firmly into the projector and

into a wall socket. The LED indicator flashes

Orange shown in Stand-by mode.

3. Remove the lens cap. If it is closed, it could

become deformed due to the heat produced by

the projection lamp.

4. Press ON/STAND-BY button on the projector or

POWER button on the remote control to start the

projector. The preparation display appears on the

screen and countdown starts.

5. After the countdown, the input source appears

on the screen.

If the frequency/resolution of the input signal exceeds the projector's operating range, you will

see the message 'Out of Range' displayed on a blank screen. Please change to an input signal

which is compatible with the projector's resolution or set the input signal to a lower setting.

Table of Contents