Remote Control Effective Range; Replacing The Battery - Eiki EIP-XSP2500 Owner's Manual

Dlp projector

Hide thumbs Also See for EIP-XSP2500:

Table of Contents

Remote Control Effective Range

Infra-Red (IR) remote control sensor is located on the

front and rear of the projector. The remote control

must be held at an angle within 20 degrees

perpendicular to the projector's IR remote control

sensor to function correctly. The distance between the

remote control and the sensor should be within 5

meters (~ 16 feet).

Ensure there are no obstacles between the remote

control and the IR sensor on the projector that might

obstruct the infra-red.

1. Pull out the battery, Please follow the illustrated

instructions. Push and hold the locking arm

while pulling out the battery holder.

2. Insert the new battery in the holder. Note the

positive polarity should face outward.

3. Please use Lithium Battery CR2025.

CAUTION

Avoid excessive heat and humidity.

Placing battery with incorrectly process may cause battery damaged.

Replace only with the same or equivalent type of battery recommended by the battery

manufacturer.

Dispose of the used battery in accordance with the battery manufacturer's instructions.

Never throw batteries into a fire; it will cause batteries explosion.

If the batteries are dead or if you will not be using the remote control for a long time, remove the

batteries to prevent battery acid from leaking into the battery compartment.

Table of Contents