Advertisement
Connect the water line to the refrigerator.
1) Slip the compression nut through the provided
plastic tubing.
2) Tighten the compression
nut onto the 1/4"
compression
fitting.
Do not overtighten the compression
nut.
NOTE
, Using Copper Tubing
- Slip the compression nut and ferrule on
copper tubing as shown.
, Using Plastic Tubing
- Insert the molded end of the plastic tubing
into the compression fitting.
3) Tighten the compression nut onto the com-
pression fitting.
4) Turn water on and check for any leakage.
C_
NOTE
Refrigerator
]
Ferrul
""
*'"
Cod)i°
b
•
i([_.......z,_ Compression Nut (1/4")
•
(Provided)
_ _Cornpresslon
Fitting
-_
I
.
!
(Provided)
3ressionNut(1/4")
(Purchased)
Plastic Tubing
Cc
(Purchased)
(Purchased)
Household Water Line
Water line must be connected to drinkable Water only.
Cut off 1/4 inch of the provided plastic tubing squarely to prevent leaks when reconnectingl
(Case 2)
Check the water supply line
Connect the water pipe with coupler and tap.
- Close the main water tap.
- Connect coupler "A" to the tap.
- Every joint should be protected with sealing tape.
Note:
!f the COuplerdoes not fit Onthe current tapl gO
the nearest authorized service dealer and purchase ..............
the right coupler fittings,
o
The water fine must be connected
to the cold water pipe.
If it is connected to the hot water
pipe, it may cause the
purifier to malfunction.
TAP
Connect the water line to the refrigerator.
- Remove the compressor cover of the refrigerator.
WATER LINE
- Connect the water line to the valve, as shown in the figure.
- When connected, check if there is any leakage.
If any, repeat the connection.
- Reattach the compressor cover of the refrigerator.
CONNECTION NUT
33
COMPRESSOR COVEROF
REFRIGERATOR
Advertisement
