Advertisement
if the Arctic Select Zone Door
is lower than the Fresh Select Zone Door.
I
!
,' adjustment part
Arctic Select Zone-
-
Fresh Select Zone
Locate the height-adjuster (dP)in the Arctic Select Zone.
Unscrew the four phillips screws ((2))slightly to loosen the door.
2) Unscrew the adjuster-phillips screw ((3))two turns to rotate the adjuster.
3) Find the best adjuster-level to align the door gap.
f
i
f
gap :T _:
I_
IArctic Se_tzo.e Door III_or]
reference plane
CASE) The gap is about 2mm (0.08inch) as shown below.
- Rotatedown the adjuster-face with +2.0 numberto reducethe door gap.
- The numberof the adjusterto rotate dependson the gap.
After adjustment,
tighten
the screws (@ & @) in reverse order.
The adjuster inthe Fresh Select Zone Canbe used in the same Way':
NOTE
23
Advertisement
