Using Your Mobile Phone 47; Configuring Your Dryer's Network Settings; Your Dryer - Samsung DV457E User Manual

LJ inGVoLAr mo i
__J J I
e
CAUTION
•
e
e
e
®.
e
_This
You can receive notifications and control your dryer from your mobile phone, To do
this, you need to do the following,
1. Setup a Wi-Fi network for your dryer
2. Turn on the Wi-Fi networking function of your dryer
3. Download and run the mobile app, Samsung Smart Washer/Dryer App
4. Use the mobile app, Samsung Smart Washer/Dryer App
No wired or wireless router (AP) is provided when you purchase your washer. The washer supports
the Wi-Fi encryption protocols, WEE TKIP and TKIP AES. It does not support connecting to a wired or
wireless router (AP) that uses a Wi-Fi encryption protocol other than these.
If a wireless router (or Access Point) is not WPS authenticated, a connection failure might occur.
If a wireless router that is not WPS authenticated is connected wirelessly to an air conditioner, the
Wi-Fi connections of other previously connected units might be disconnected.
If this appliance is installed in a building where no wireless router (AP) is installed for that floor, the
network connectivity may be degraded.
If this appliance is installed in a location such as inside a utility closet made from metal or reinforced
concrete, the network connectivity may be degraded.
If this appliance or the wireless router (AP) is installed near a microwave or drier, the network
connectivity may be degraded due to interference.
If the wireless router (AP) is a non-certified product, this appliance may not connect to the network.
This appliance does not support the wireless networking protocols 802.11 n and 802.11 a.
product does not contain a wireless router.
CONFIGURING YOUR DRYER'S NETWORK SETTINGS AND
CONNECTING TO YOUR NETWORK
To configure your washer's Wi-Fi settings and connect your washer to your network, follow the procedures
below.
Confiquring the IP address settings
Follow the procedure below to configure the IP address settings of your dryer for a Wi-Fi
network.
1. Tap the Settings button in the Cycle
Selection screen.
2. Tap the Network menu in the Settings screen.
3. Tap the Wi-Fi network section.
4. Tap the Configure button.
5. Tap the IP Address button next to the network
you want to configure.
6. Tap the Automatic button to have your dryer
configure the IP address settings automatically,
and then go to Step 11. If you need to
configure the IP address and other settings
manually, go to Step 7.
7. Tap the User Config button to configure the IP address settings manually.
8. Tap the IP address field.
9. Enter an IP address and then tap the OK button.
10. Repeat steps 8 and 9 for the Subnet mask, Gateway, and DNS fields.
1 t. Tap the OK button in the Settings screen.
Using your mobile phone 47
I DV457E(GF02836E ENindd 47 2012-04-09 D_4:15:47