Samsung DV457E User Manual page 163

Gas and electric dryer
Hide thumbs Also See for DV457E:
Table of Contents

Advertisement

ELECTRICAL
CONNECTIONS
Before operating
or testing,
follow all grounding
instructions
in the "Grounding"
section on page 18.
An individual
branch (or separate)
circuit serving only your dryer is recommended.
DO NOT USE AN
EXTENSION
CORD.
Gas models - U.S. and Canada
A 120 volt, 60 Hz AC approved
electrical
service, with a 18-ampere
fuse or circuit breaker is
required.
Electric
models
- U.S. only
Most U.S. dryers require a 120/240
volt, 60 Hz AC approved
electrical
service.
Some require
120/208
volt, 60 Hz approved
electrical
service.
The electric service requirements
can be found
on the data label located
behind the door. A 30-ampere
fuse or circuit breaker
on both sides of
the line is required.
If a power cord is used, the cord should be plugged
into a 30-ampere
receptacle.
The power cord is NOT provided
with U.S. electric model dryers.
Z/_X RISK OF ELECTRIC
SHOCK:
WAR,_,G
When local codes allow, the electrical
supply of the dryer may be connected
by means of
a new power supply cord kit, marked for use with a dryer, that is U.L listed and rated at a
minimum
of120/240
volts, 30-ampere
with three No. 10 copper
wire conductors
terminated
with closed
loop terminals,
open-end
spade lugs with turned up ends, or with tinned leads.
Do not reuse a power supply cord from an old dryer. The power cord electric supply
wiring
must be retained
at the dryer cabinet
with a suitable
UL-listed
strain relief.
Grounding
through
the neutral conductor
is prohibited
for (1) new branch-circuit
installations,
(2) mobile homes,
(3) recreational
vehicles,
and (4) areas where local
codes
prohibit grounding
through the neutral conductor.
(Use a 4-prong
plug for 4 wire
receptacles,
NEMA type 14-30R.)
Electric models - Canada Only
A 120/240
volt, 60 Hz AC approved
electrical
service fused through
a 30-ampere
fuse or
circuit
breaker on both sides of the line is required.
All Canadian
models are shipped
with the power
cord attached.
The power cord should
be
plugged
into a 30-ampere
receptacle.
[_
In Canada,
not convert
to 208 volts.
you may
a
dryer
Installing
your dryer 19
I
DV457E(GF02836E
ENindd
19
2012-04-09
D_4:15:41

Advertisement

Chapters

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Dv457g

Table of Contents