Samsung DV457E User Manual page 311

5°
6.
Review the "Electrical requirements" section on page 18.
BEFORE OPERATING OR TESTING, follow the grounding instructions in the "Grounding"
section on page 18.
U.S. MODELS:
WAR_=_G RISK OF ELECTRIC SHOCK - All U.S. models are produced for a 3-WIRE SYSTEM
CONNECTION.
The dryer frame is grounded to the neutral conductor at the terminal block.
A 4-WIRE SYSTEM CONNECTION is required for new or remodeled construction,
mobile homes, or if local codes do not permit grounding through neutral. If the 4-wire
system is used, the dryer frame cannot be grounded to the neutral conductor at
the terminal block. Refer to the following instructions for 3 and 4-WIRE SYSTEM
CONNECTIONS.
Remove the terminal block cover plate.
Insert the power cord with a UL-listed strain relief through the hole provided in the cabinet
near the terminal block.
_A strain relief be used.
must
Do not loosen the nuts already installed on the terminal block. Be sure they are tight.
Use a 3/8" (1 cm) deep well socket.
Review the "Gas requirements" section on page 17. Remove the pipe thread protective
cap. Apply a pipe joint compound or about 1 1/2 wraps of Teflon tape over all threaded
connections.
[_The must be resistant to the actions of
pipe joint compound liquefied petroleum any
gas.
Connect the gas supply to your dryer. An additional fitting is required to connect the 3/4" (1.9
cm) female thread end of a flexible connector to the 3/8" (1 cm) male threaded end on the
dryer.
Securely tighten the gas line fitting over the threads.
Turn on the gas supply.
Check all gas connections for leaks using a soap solution.
If bubbles appear, tighten the connections and recheck. DO NOT use an open flame to
check for gas leaks.
Installing your' dryer 23
I DV457E(GI-02836E ENindd 23 2012-04-09 _4:15:42