Samsung DV457E User Manual page 453

Method 2
The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old
hoses.
1. If the "Y" connector cannot be attached directly to the cold
water faucet, the short hose must be used.
2. Turn the cold water faucet off.
3. Attach the short inlet hose to the cold water faucet.
Screw on the coupling by hand until it is seated on the
faucet.
4. Using the pliers, tighten the coupling with an additional two-
thirds turn.
[_ not overtighten, as may damage coupling.
Do this the
5. Attach the 'Y" connector to the brass male end of the small
hose. Screw on the coupling by hand until it is seated on the
connector.
6. Using the pliers, tighten the coupling with an additional two-
thirds turn.
[_ overtighten, as may damage coupling.
Do not this the
7. Attach the angled end of long hoses to the fill valve at the
bottom of the dryer rear frame. Screw on the coupling by
hand until it is seated on the fill valve connector.
8. Using pliers, tighten the coupling with an additional two-
thirds turn.
not overtighten, as may damage coupling.
Do this the
9. Check that the water faucets are on.
10. Check for leaks around the "Y" connector, faucets and
hoses.
Duct Exhaust /
_ _"_'_ _LF ....
_ """""_ Water Hose
Installing your _dryer 21
I DV457E(GI-O2836E ENindd 21 2012-04-09 D_4:15:42