Installation - Samsung DV457E User Manual

REPLACEMENT PARTS AND ACCESSORIES
If your dryer requires replacement parts or accessories, contact the dealer where you purchased your dryer
or the SAMSUNG customer care center at 1-800-SAMSUNG (726-7864).
INSTALLATION
For the proper installation, we recommend that you hire a qualified installer.
To install
t. Level
2.
3.
Move your dryer to an appropriate location for the
installation. Consider installing the dryer and washer side-
by-side, to allow access to the gas, electrical, and exhaust
connections. Place two of the carton cushion-tops on the
floor. Tip your dryer on its side so it lies across both cushion-
tops.
Set your dryer back in an upright position.
To ensure that the dryer provides the optimal drying
performance, it must be level. To minimize vibrations, noise,
and unwanted movement, the floor must be a perfectly level,
solid surface.
To set the dryer to the same height as the washer,
fully retract the leveling feet by turning them
counterclockwise, then loosen the legs by turning them
clockwise.
Leveling feet
Retract fully i Then loosen
[_ djust the leveling feet only as much as necessary to
level the dryer. Extending the leveling feet more than
necessary can cause the dryer to vibrate.
Review the "Exhausting" section on page 16 before installing the exhaust system. Install the
ductwork from your dryer to the exhaust hood. The crimped end of the duct sections must
point away from your dryer.
DO NOT use sheet metal screws when assembling the ducting. These joints should be
taped.
Never use plastic flexible exhaust material.
Tip for tight installations: install a section of the exhaust system onto your dryer before putting
it in place.
Use duct tape to secure this section to your dryer, but do not cover the ventilation slots at
the back of the unit in dryer cabinet.
22 Installing your dryer
I DV457E(GF02836E ENindd 22 2012-04-09 D_4:15:42