Important To Installer; Alcove Or Closet Installations - Samsung DV457E User Manual

If the new dryer is installed into an existing exhaust system you must make sure:
• The exhaust system meets all local, state, and national codes.
• That a flexible plastic duct is not used.
• To inspect and clean all lint buildup from inside the existing duct.
• The duct is not dented or crushed.
• The exhaust hood damper opens and closes freely.
The static pressure in any exhaust system must not exceed 0.83 inches of water column, or be less than 0.
This can be measured with the dryer running with a manometer at the point where the exhaust duct
connects to the dryer. A no-heat setting should be used. The dryer tumbler should be empty and the lint
filter clean.
IM PORTANT TO INSTALLER
Please read the following instructions carefully before installing the dryer. These instructions should be kept
for future reference.
_ Remove the door from all discarded appliances to avoid the danger of a child being trapped and
WARN_,G suffocating.
LOCATION CONSl DERATIONS
The dryer should be located where there is enough space at the front for loading the dryer, and enough
space behind for the exhaust system. This dryer is factory-ready for the rear exhaust option. To exhaust out
the bottom, right or the left, use the accessory exhaust kit. Instructions are included with the kit. Make sure
the room in which the dryer is located has enough fresh air. The dryer must be located where there are no
air-flow obstruction.
For gas dryers, adequate clearance must be maintained as noted on the data plate to ensure adequate air
for combustion and the proper dryer operation.
The dryer must not be installed or stored in an area where it will be exposed to water and/or weather. The
dryer area must be kept clear of combustible materials, gasoline, and other flammable vapors and liquids. A
dryer produces combustible lint. The area around the dryer should be kept lint-free.
ALCOVE OR CLOSET INSTALLATIONS
z_The dryer must be exhausted to the outside to reduce the risk of fire when installed in an alcove or
W,_RN_G closet.
• No other fuel-burning appliance should be installed in the same closet as the dryer.
• WARNING: To reduce the risk of fire, this dryer must be exhausted to the outside. Refer to "Exhausting"
section on page 16.
• Minimum clearances between the dryer and adjacent walls or other surfaces are: 2" in front, 17" on top,
1" on either side, and 8" at the back.
• The front of the closet must have two unobstructed air openings for a combined minimum total area
of 72 in2 with a minimum clearance of 3" at the top and bottom. A slatted door with equivalent space
clearances is acceptable.
Installing your dryer 15
I DV457E(GF02836E ENindd 15 2012-04-09 D_4:15:41