Connecting The Inlet Hose - Samsung DV457E User Manual

CONNECTING THE iNLET HOSE
Method 1
The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old
hoses.
t. If space permits, attach the brass female end of the "Y"
connector to the cold water faucet.
2. Turn the cold water faucet off.
3. Attach the straight end of long hose to the "Y' connector.
4. Using pliers, tighten the coupling with an additional two-
thirds turn.
[_ not overtighten, as may damage coupling.
Do this the
5. Attach the angled end of long hoses to fill the valve at the
bottom of the dryer's rear frame. Screw on the coupling by
hand until it is seated on the fill valve connector.
6. Using the pliers, tighten the coupling with an additional two-
thirds turn.
_} overtighten, as may damage coupling.
Do not this the
7. Check that the water faucets are on.
8. Check for leaks around the "Y" connector, faucets and
hoses.
Exhaust
Water Hose
20 Installing your _dryer
I DV457E(GI-O2836E ENindd 20 2012-04-09 D_4:15:41