About Programming The Remote; Testing The Remote; Programming The Remote - ProScan PSVR74 User Manual

ABOUT PROGRAMMING THE REMOTE
The universal remote's TV and SAT-CABLE buttons can be
programmed to control other brands of remote controllable TVs,
digital satellite receivers, and cable boxes either by using the Code
Search feature or Direct Entry. It is already programmed to operate
most ProScan, RCA, and GE televisions and digital satellite receivers.
The AUX button can be programmed to control a ProScan, RCA or GE
auxiliary component.
TESTING THE REMOTE
To determine whether the universal remote needs to be programmed,
turn the component on (such as a TV), point the remote at the TV, and
press the TV button. Then press ON-OFF, CH /', or OH v to see if the
TV responds to the remote commands. If the TV does not respond, the
remote needs to be programmed.
PROGRAMMING THE REMOTE
Your remote can be programmed using Automatic Code Search or
Direct Entry.
Using Automatic Code Search
The remote features Code Search, a technology that largely automates
the programming process. Follow these steps to program the remote.
1. ]-urn on the component you want to control (TV, digital satellite
receiver, or cable box).
2. Press and hold the button you want to program (TV or
SA-[,CABLE). While holding the component button, press and
hold ON-OFF until the red light (LED-light emitting diode) on the
remote flashes, then release both buttons.
3. Press and release PLAY, then wait five seconds.
The remote searches through a set of codes. If, after five seconds,
the component does not turn off, press PLAY again to tell the
remote to search the next set (20 total) of codes.
4. Repeat step 3 until the component turns off or you have searched
through all of the code sets.
40
LED
_t.T0511
0
RL_IRA R_'
You'll use these buttons when you
program the remote to control aTV,
digital satellite receiver, or cable box.