Channels - Mitsubishi HS-U560C Owner's Manual

Memorize channels
Your cable box sends a
signal on which channel?
Brand code 1
3
Use ADJUST to select.
and ENTER. Press
MENU for Set-Up Menu
Memorize channels
Your cable box sends a
signal on which channel?
Brand code 1
_ L1
Use ADJUST to select,
and ENTER. Press
MENU for Set-Up Menu
Memorize channels
Now memorizing all the
stations you can receive
Channel 3
Stand by this may take
a few minutes
To cancel memorization.
press CANCEL
_Important:
_>Important:
0
0
After you have selected the manufacturer's code, turn the
shuttle ring right. The cursor will move to "Channel."
Use the ADJUST dial to select the channel on which your
cable box sends a signal to the VCR. If you connected your
cable box with audio/video cables, use the INPUT button to
select "LI".
O
You need to determine whether or not you have selected the
correct "Brand ,:ode." To do this, press the CHANNEL buttons
on the remote control. A,_you press the buttons, the channel
number on front of your VCR should change. Watch your
cable box. Your cable box should show the exact same number
a moment: after it appears on your VCE.
@
If your cable box does not change channels at all, or does not
show the exact same number do one of_;he following:
• Try repositioning or moving the cable box on top of the
VCR.
• If more than one "Brand code" is listed for your type of
cable box, try a different one. (You can use the CANCEL
button to move back to the "Brand code" option.)
After you have determined that you are using the correct
Brand Code, turn the shuttle ring right to begin meraorizing
channels. The TV screen will show you a message that tlhe
VCR is memorizing the channels coming from your cable box.
Your TV screen: the frolrt of your VCR, and you cable box
should all display each channel number, one by one.
If a code number is not listed for your type of cable box, or if none
of the numbers listed will work, try each code, from 01 to 94, one
at a time.
If your cable box cannot be controlled by a remote control (e.g., if
you have a "slide"-type cable box), then your VCR will not be able
to change channels on the cable box.
If your cable box will not respond to any of the codes, your VCR
cannot change channels on the cable box. You will need to change
channels yourself, using the cable box's remote control. You
should re-program your VCR, choosing "Cat:,le" in step @ on page
32. When programming to record, you will need to leave your
cable box ON and tuned to tlhe channel you wish to record.
When the VCR is finished memorizing, it will return to the VCR's
picture.
Automatic programming may include vacant channels if there
was a noise or stray signal on the channel. If this occurs, you can
manually delete the channels using the procedure in the section
"Adding and deleting channels".
33