Table of Contents
Advertisement
Chapter 3: Operating YourVCR
SettingUp YourVCRfor the Firstlime (cont.)
_>Important:
0
If you tuned the TV to channel
4 in step O, press the CHAN-
NEL
•
button
and the ONE KEY PRO3RAM
button
on the
front panel at the same time with the VCR tuned off. The
word "Ant ch4" will display
on the front
panel display' and the
VCR will send signals
on channel
4. (If you tuned the TV to
channel
3, you don't need to do this.)
O
Turn the VCR on by pressing
the POWER
button.
The VCR will return
to its initial
setting
(channel
3) if you press
the CHANNEL
•
button
and the ONE KEY PROGRAM
button
on the front panel at the same time with the VCR turned
off.
Setting up your VCR if you are using a TV equippedwith Audio
and Video Inputs (Moden
TV} i
Turn on your TV and switch
it to the correct external
input.
(For most Mitsubishi
TVs, this means
pressing
the TV's
INPUT
button
until you see the words "Ext-l"
on the screen.)
Turn the VCR on by pressing
the POWER
button.
Usingthe RemoteControl
In this section, you'll learn how to set up an] use your remote
control
This section
includes:
• Using the remote
control
to operate
the VCR, and
• Using
the remote
control
to operate
the TV.
Usingthe remotecontrol to operate the VCR
installing the batteries
°
,,i,
•
®®
•
•
Unpack
two AAA size batteries.
To remove
the back cover, press the ridged area gently, then
push the cover in the direction
of the ar:'ow and lift.
Load the batteries,
making
sure the polarities
(+) and (-) are
correct.
operating the remote control
The HS-U270
has two VCR operation
modes: VCR-A mode and
VCR-B mode.
The HS-U270
is pre-set
to VCR-A operation
mode.
Set the TV/VCR slide switch
on the remote
control
to VCR
position.
This "tells" the remote that
you want to control
the
VCR.
Press the DISPLAY
button
and the number
button
"!" on the
remote
control
at the same time.
Now your remote
is ready to
operate
your HS-U270.
2O
Advertisement
Table of Contents
