Mitsubishi VS-5041 Owner's Manual page 44

Using the remote control
operating Mitsubishi components
Your remote control unit comes programmed to operate Mitsubishi
Projection TVs and VCRs. The select buttons (across the top of the
remote control) determine which component the remote control will
operate.
The following buttons are available
• power button
• pause button
• mute control
• super quick view button
• quick view button
• volume control
• input button
• channel control
• enter button
• audio and video controls
when using this Projection TV:
• menu button
° cancel button
• display button
• hom_ button
• off-timer button
• number buttons
• PIP controls
• PLAY button
• quick program button
operating VCRs or cable boxes from other manufa_cturers
The remote control is pre-set to operate Mitsubishi VCRs, but it
can also operate VCRs from other manufacturers as well. If you
have a VCR 5"om another manufacturer, or if you have a cable box,
you should "set up" the remote control.
Each layer (CABLE, VCR-A ,or VCR-B) can be set for either a cable
box or a VCR.
setting up the remote control to operate your VCR
O Turn off your VCR.
Press one of the select buttons across the top of the remote
control to choose the layer that you want to "set up." You can
choose between VCR-A, VCR-B or CABLE.
O
While holding in the POWER button o_ the remote control,
enter the code number listed in the chart on the following page
for your brand of VCR. Be sure to enter both digits of the code
number. If more than one number is listed, try the first one.
Release the POWER button.
Press the POWER button again. Your VCR should turn on. If
the VCR _urns on, your remote control :is now set to operate
your VCR.
Getting Started 45