Table of Contents
Advertisement
_Important:
>Important:
_Important:
procedure
(See illustration
on the following
page.)
O
Connect
the incoming
cable to the IN terminal
on the two-way
splitter.
O
Connect
a coaxial cable to one of the GUT terminals
on the
splitter,
connect
the other end of this cable to the ANT-A
terminal
on the back of the Projection
TV.
Connect
a second coaxial cable to the other
OUT te_:minal on
the splitter;
connect
the other end of this cable to the IN
terminal
on the decoder
box.
O
Connect
the third coaxial cable to the OUT terminal
on the
back of the decoder
box:, connect
the other end of this cable to
the ANTENNA-IN
terminal
on the back of the VCR.
Connect
the fourth
coaxial cable to one of the ANTENNA-OUT
terminals
on the back of the VCR. Connect
the other end of this
cable to the ANT-B terminal
on the back of the Projection
TV.
Connect
an RCA pin-type
video cable to the VIDEO OUT
terminal
on the back of the VCR. Connect
the other end to the
VIDEO INPUT
terminal
on the back c,f the Projection
TV.
If you are connecting
a Super VtIS (S-VHS) VCR, use a Super
Video cable instead
of an RCA pm-type
video cable. Connect
a
Super Video cable to the S-VIDEO
OUT terminal
on the VCR.
Connect
the other end of this cable to the S-VIDEO
INPUT
termi-
nal on the back of the Projection
TV.
O
Connect
a set of RCA pin-type
audio cables to the AUDIO OUT
terminals
on the back of the VCR. Use the red cable to connect
the right (R) channel
and the white cable for connecting
the left
(L) channel.
O
Connect
the other ends of this cable to the AUDIO INPUT
terminals
on the back of the Projection
TV.
If your VCR is monaural
(non-stereo),
you will only connect a single
RCA pin-type
audio cable. Connect
the cable to the VCR, then
connect
the other end to the L (LEFT)
audio input
on the back of
the Projection
TV.
If your VCR has a video channel
switch, set it to "OFFiAV."
See
your VCR's owner's
guide for details.
Basic Connections
35
Hide quick links:
Advertisement
Table of Contents
