88
Appendices
Picture
tion graphics.
5.
When viewing a stopped VCR, white lines are
rolling on the screen.
tmage, or the colors are dim, or the screen is
black.
quality).
•
Turn off video mute for the VCR.
Begin playing the tape.
•
Change the VCR input to the antenna input.
......
Tfi
an
S been incot r
y Set
ese
e..............................
PerfectColor
balance.
If the signal is 1080p, upgrade a Category 1 (unmarked) HDMI
cable to a Category 2 high-speed
HDMI cable.
turned up.
•
The TV's "Listen to:" audio setting may be set to SAP.
Check that the Speakers option is set to TV to hear sound from the TV
speakers.
If using an A/V receiver, check that the Speakers option is set to AV
Receiver to hear sound from the A/V receiver speakers.
Perform a System Reset.
.......
21..........................
toAVReceiverl
but
it is noi Possibie io hear audio from the A/V receiver if the foiiowing three .............................
hear sound from the TV speakers instead of
conditions
apply:
the A/V receiver.
•
The A/V receiver is connected
to the TV via HDMI only and
•
The source is connected to the TV only, e.g., to ANT 1 and
•
The TV's audio output is not connected
to the A/V receiver
To hear audio through the A/V receiver, connect it to the TV's AVR AUDIO
OUTPUT or DIGITAL AUDIO OUTPUT jack(s).
3.
The sound does not match the screen
The TV's Listen to: setting may be set to SAP. See page 44.
picture.
4.
The sound from my A/V receiver does not
Check that DIGITAL AUDIO OUTPUT and/or AVR AUDIO OUTPUT on TV's
match the screen picture (I should hear the
main panel is connected to the A/V receiver.
correct audio from my A/V receiver).
Without this connection, devices connected only to the TV (and not
the A/V receiver) can be heard only from the TV speakers.
Note that
this includes the ANT l/ANT 2 inputs, a device (such as a camcorder)
connected to the convenience jacks, and any other device sending audio
to the TV only.
®
Check A/V receiver input selection in the Inputs > AV Receiver menu. If
NetCommand is set up incorrectly for the A/V receiver, see "A/V Receiver
Control: Automatic Audio Switching," page 62.
5.
': The sound from my A/V receiver does not
•
Check A/V receiver input selection in the Inputs > AV Receiver menu. If
match the screen picture (my source device
NetCommand is set up incorrectly for the A/V receiver, see "Setup to Control
should be sending both audio and video
Automatic Audio and Video Switching via HDMI,' page 65.
through the A/V receiver).
•
The TV s Listen to: setting may be set to SAP. See page 44.
6.
Cannot select an audio-only
device; it does
Plug a video plug into any composite
VIDEO jack for the Auto Input Sensing
, not appear in the Input Selection Menu.
, screen to appear.
See "Audio-Only
Device," page 26.