Mitsubishi LT-46149 Owner's Manual page 71

Appendices 71
Programming the Remote Control
3,
Move the slide switch at the top of the remote to
the position for the product you want to control.
Refer to the table below. Only one of each device
type can be controlled in each slide-switch position.
CABLE/SAT Cable Box
DTV Receiver
Satellite Receiver
VCR VCR
DVR
Laser Disc Player
DVD Player/Recorder
DVD DVD Player/Recorder
DVR
Laser Disc Player
VCR
AUDIO _:A/V Receiver
...... Audio Amplifier
CD Player
2, Press and hold POWER on the remote control for
several seconds until the button blinks twice and
goes off.
3, Releasethe POWER button.
4, Enter the first five-digit code listed for your equip-
ment.
• The POWER button blinks twice when you start to
enter the code and then once for each addi-
tional keypress.
The POWER button blinks twice when you finish
entering a valid code.
Move the slide switch to another position if you
need to start over or wish to exit programming
mode.
Point the remote control at the equipment and
press POWER. If the product has no power on/off
function, press a different key, such as @ (PLAY),
(STOP), V0L/% or MUTE.
= If the equipment responds, the remote control
is properly programmed to operate the equip-
ment.
= If the equipment does not respond, repeat
steps 2-4 with the next five-digit code listed for
your equipment.
& Once you have found the correct code, write it in
the space below for future reference.
CABLE/SAT
McR
i
Code Verification
To determine the code programmed for any position of
the slide switch:
3, Move the slide switch to the position you wish to
verify.
Press and hold POWER on the remote control for
several seconds until the button blinks twice and
goes off.
3, Press keys9 9 0
4, Press 1 and count the blinks of the power button.
Write down the number of blinks as the first digit of
the code.
Repeat step 4 for the second, third, fourth, and fifth
digits of the code.
Audio Lock: Universai A/V Receiver Control
With Audio Lock active, the remote control operates
the volume and mute functions of the A/V receiver in all
positions of the slide switch. Activate Audio Lock if you
normally use an A/V receiver with your TV and other
A/V equipment.
3, Program the AUDIO position for your A/V receiver as
described earlier in this section.
With the slide switch in the AUDIO position, press
and hold POWER on the remote control for several
seconds until the button blinks twice and goes off.
3, Press keys 9 9 3 ENTER
The POWER button will blink twice to indicate Audio
Lock is active.
To Reset the Remote Control to Operate Volume
and Mute for the TV Speakers
3, Press and hold POWER for several seconds until the
key blinks twice and goes off.
Press keys 9 9 3 V0L/_.
The POWER key will blink four times to indicate Audio
Lock has cleared.