Control Of An A/V - Mitsubishi LT-46149 Owner's Manual

6. NetCommand IR Control 59
Operating NetCommand=Controlled Devices
Controlling Most Device Types
As an example of NetCommand control, if you are watch-
ing your cable box and you wish to tune to the next
channel higher, press OH/PAGE ix NetCommand then sends
the "learned" channel-up control signal to the cable box.
1, With an IR emitter properly positioned in front of the
device, use the Inputs > Learn screen to perform
NetCommand setup for the device.
When you wish to use the device, press INPUT t o
display the Input Selection menu.
3, Press A Y 4 I_ to highlight the icon for the device.
4, Press ENTER to switch the TV to the device.
Note: if you have set up automatic input switching for the
AN receiver, the AN receiver will automatically
switch to the correct input for the device,
To operate the device using the TV's remote
control, set the slide switch to the TVposition.
6, Point the remote control at the TV (not the device)
and press the key for the desired function.
Special Operation Methods
Controlling an A/V Receiver
See page 61 to set up control of an A/V receiver.
Switching Audio to and from the A/V Receiver
1, Press AUDIO.
Press A to show the Speakers option.
3, Press _, to select either AV Receiver or TV.
I, Press AUDIO.
Press A V to show the Speakers option.
3, Press II_to select AV Receiver.
4, Point the remote control at the TV (not the A/V receiver)
and press POWER to power the A/V receiver on or off.
A/V Receiver Functions
With the A/V receiver powered on and selected, the
TV's remote operates the volume and mute functions.
Also, when you switch to a device in the Input Selec-
tion menu, the A/V receiver automatically switches to
the correct audio input for the device.
Power On Manual Power On/Off
Use for devices that have only one POWER key.
1. Press INPUT t o display the Input Selection
menu.
2. Press A V 4t I_ to highlight the icon for the
device to be powered on or off.
3. With the Input Selection menu still displayed,
press POWER to send the power signal; you may
need to press POWER twice.
Power On
Power Off
Menu
Automatic Power On/Off
This feature is only for devices that have separate
POWER ONand POWER OFF keys on their original remote
controls. If your device does not have a separate
POWER OFF key, do not use the Power Off learn-
ing position: use only the Manual Power ON/OFF
method described above.
In the NetCommand Learn screen:
a. "Learn" the Power On command in the Power •
On learning position.
b. "Learn" the Power Off command in the
Power Off learning position,
Displaying the Menu for a Device 1.
Note:
4.
,
.
If you press POWER without the Input Selec=
tion menu displayed, the TV will turn off.
Press ENTER to switch the TV to the device.
To Power On the Device
1. Press INPUT t o display the Input Selection
menu.
2. Press A V _1 I_ to highlight the icon for the
device to be powered on or off.
3. Press ENTER to switch the TV to the device
and NetCommand will send the Power On
command to the device.
To Power Off the Device
When you turn the TV off, the TV sends all
learned Power Off commands to all devices.
While watching a device, press INPUT t o display
the Input Selection menu with the device icon
highlighted.
Press MENU to send the menu signal to the
device. The Input Selection menu will auto-
matically clear from the screen.