Mitsubishi LT-46149 Owner's Manual page 16

16 2. TV Setup
Tips on Auto Sensing and Changing
Connected Devices
• Choose a different name for each input.
Antenna inputs (ANT l/ANT 2) are never detected,
although you can turn off unused antenna inputs in the
Inputs > Name menu.
• You can change the device type displayed in the Input
Selection menu by using the Inputs > Name menu (page
51). Any "learned" NetCommand IR codes will be erased,
however.
Changing Oevices on an HDM! lnput
1, Disconnect the HDMI device.
Delete the HDMI input in the Inputs > Name menu.
See page 51.
3, Connect the new device and the Auto Input
Sensing screen will display. If you want the device
under NetCommand IR control, perform NetCom-
mand "learning" for the new device.
Disconne Receiver
When you disconnect an analog A/V receiver, be sure
to change the Speakers setting to TV to:
• Hear sound from the TV speakers.
Redisplay the Auto Output Sensing screen when
you reconnect a device to the AVR AUDIO OUTPUT.
Change the setting using the remote control's AUDIO key
or the AV > Audio > Speakers menu.
Resetting the SUBWOOFER OUTPUT Jack (AVR
AUDIO R)
Follow these steps to enable redisplay of the Auto
Output Sensing screen.
1, Repeatedly press the AUDI0 key to display the Sub=
woofer option and change it to Off.
Power off the TV.
Disconnect the subwoofer from the TV.
3.
4.
Power on the TV.
Connect the device to the SUBWOOFER OUTPUT
(AVR AUDIO R) jack and theAuto Output Sensing
screen will display.
Use one of the methods below to control sound volume from
the A/V receiver.
With a Standard TV Setup
,, Recommended Method: Program theTV's
remote control for your A/V receiver and enable the
Audio Lock feature. See page 71.
Program the TV's remote control for your A/V
receiver and set the TV remote's slide switch to the
A[JDI0 position to control A/V receiver volume. Set
the switch back to the TVposition to control the TV.
Use the remote control that came with the A/V
receiver.
With NetCommand IR Control
Set up NetCommand control of the A/V receiver's
volume functions in the Inputs > AVR menu. The TV's
remote will then control A/V receiver volume. See page
61.
With NetCommand for HDMI (CEC=Enabled
HDMI A/V Receiver)
The TV's remote control may control some functions
of the A/V receiver. See "About Home-Theater Control
Systems," page 17 and Appendix E, "NetCommand
HDMI Control of CEC Devices," page 81.